Sunday, January 26, 2020

Study Of Solubility Equilibrium Biology Essay

Study Of Solubility Equilibrium Biology Essay The solubility product constant of potassium hydrogen tartrate in water and it dependence of temperature were investigated in this experiment. The solubility product constant was determined at different temperature through acid-base titration against NaOH. A linear graph was obtained by plotting ln Ksp against 1/T and positive correlation between temperatures and solubility product constant was observed. This study concluded that solubility product constant of potassium hydrogen tartrate is dependent only on temperature. Introduction The aim of this experiment is to investigate the solubility product constant of potassium hydrogen tartrate in water and it dependence on temperature. Solubility is often defined the amount of substance required in obtaining a saturated solution. Therefore, only a small amount of potassium hydrogen tartrate (KHC4H4O6) is needed to produce a saturated solution as it has limited solubility in water. In the saturated solution, the rate of the dissociation of the solid is the same as the rate of the aqueous ions forming the solid compound; the solution is known to be at equilibrium. The equilibrium equation for KHC4H4O6 in the solution can be written as: The constant for the equilibrium equation can be expressed as: Ksp = [K+] [HC4H4O6-]. This constant is also known as the solubility product constant (Ksp) which has a fixed value for a given system at constant temperature. Thus, by finding out the concentration of the ions dissolved, the solubility product constant for KHC4H4O6 can be determined. From the equation above, the dissociation of KHC4H4O6 will produce equal amount of potassium ions (K+) and hydrogen tartrate ions (HC4H4O6-). Thus, by obtaining the concentration of one of the ions, the concentration of the other ion can be derived and the solubility product constant can be calculated. As HC4H4O6- behaves like a weak acid, its concentration can be determined by acid-base titration using NaOH, a strong base as the titrant, with phenolphthalein as the indicator. As NaOH and HC4H4O6- react with each other in 1:1 ratio, the amount of NaOH used in the titration will be equal to the amount of HC4H4O6- present in the solution. While Ksp is fixed at a certain condition, changes in temperature will affect the value of Ksp. According to the vant hoff equation, the value of Ksp is related to the change in Gibbs free energy and can be expressed as: From the equation, the solubility product constant depends on three variables which are the change in enthalpy, the change in entropy and the temperature. The change in entropy and enthalpy with respect to temperature were stated to be insignificant due to the similar heat capacities of the product and reactants. This suggests a linear trend between the remaining variable and Ksp [1]. Therefore, a graph of natural logarithm of Ksp versus the reciprocal of temperature can be plot which the gradient of the graph can be used to calculate the enthalpy change and the y-intercept for the entropy change. Thus, the relationship between Ksp and temperature can be observed. Experimental Procedure Dried KHC8H4O4 (0.5002 g) was prepared in a 250 mL conical flask with the help of an analytical balance. Deionized water (25.0 mL) was added into the flask and a standard solution of KHC8H4O4 was obtained. The prepared solution was then titrated against an unknown concentration of NaOH to the endpoint, with phenolphthalein as the indicator. The volume of NaOH used was recorded. The entire procedure was then repeated with different masses KHC8H4O4 (0.5039 g, 0.5033 g). The concentration of the NaOH was calculated from the volume of NaOH used and tabulated in Table 1. A saturated KHC4H4O6 solution was prepared by adding one gram of KHC8H4O4 into a 250 mL conical flask, containing 100.0 mL of deionized water. The flask was swirled for five minutes and put to rest with occasional swirling for another five minutes at room temperature. At the end of ten minutes, the solution was then filtered and the supernatant was collected in a dry 250 mL conical flask. Concurrently, the temperature of the solution in the filter funnel was recorded. Two portions of 25.0 mL of the filtered solution were then pipetted into two separate 250 mL conical flasks. The two solutions were titrated against the 0.7070M NaOH solution to the endpoint, with phenolphthalein as the indicator. The volume of the NaOH used was recorded. The procedure was then repeated for different temperatures. For temperature above room temperature, a hot water bath was prepared in a one litre beaker on a hotplate stirrer. The saturated KHC4H4O6 solution was prepared in the same way but was placed in a hot water bath with constant stirring, using a stir bar. The solution was put aside with occasional monitoring until a constant temperature was observed. Next, the solution was decanted in small amount into a dry conical flask. The temperature of the solution in the filter funnel was recorded concurrently. Three portions of 25.0 mL of the filtered solution were then pipetted into three separate 250 mL conical flasks. For temperature below room temperature, an ice-water bath was prepared in a one litre beaker. The solution was also prepared in the same way as the previous procedure and was placed into the ice-water bath. The solution was cooled until the solution stabilized at a certain temperature. The solution was then filtered and the temperature of the solution in the filter funnel was recorded. Three portions of 25.0 mL of the filtered solution were then pipetted into three separate 250 mL conical flasks similar to the above room temperature setup. The six solutions were then placed aside for it to return to room temperature and then titrated against the standardized NaOH. The solutions were titrated the same way as the titration done at room temperature. The volume of NaOH used was recorded for the different solutions were recorded. The average volume of NaOH used for the same temperature was then calculated and tabulated in Table 2. Data Treatment and Analysis The calculations of [HC4H4O6-], [K+] and Ksp at 302.15K: [NaOH] = 7.070 x 10-2 mol L-1 Amount of NaOH used = (7.070 x 10-2 mol L-1) (1.2825 x 10-2 L) = 9.067 x 10-4 mol Amount of HC4H4O6- = Amount of NaOH used = 9.067 x 10-4 mol [HC4H4O6-] = [K+] = 9.067 x 10-4 / (0.0250 L) = 3.63 x 10-2 mol L-1 Ksp = [K+] [HC4H4O6-] = (3.63 x 10-2 mol L-1)2 = 1.32 x 10-3 The calculated value of [K+], [HC4H4O6-] and Ksp were tabulated into the table below: Table 2: Determination of Ksp of KHC4H4O6 at different temperature Temperature / K Average Vol. of NaOH used / L Amount of NaOH used / mol [HC4H4O6-] / mol L-1 [K+] / mol L-1 Kspof KHC4H4O6 285.15 7.4750 x 10-3 5.327 x 10-4 2.13 x 10-2 2.13 x 10-2 4.54 x 10-4 294.15 1.0075 x 10-2 7.180 x 10-4 2.87 x 10-2 2.87 x 10-2 8.25 x 10-4 302.15 1.2825 x 10-2 9.067 x 10-4 3.63 x 10-2 3.63 x 10-2 1.32 x 10-3 309.15 1.6375 x 10-2 1.158 x 10-3 4.63 x 10-2 4.63 x 10-2 2.14 x 10-3 320.15 2.2375 x 10-2 1.582 x 10-3 6.33 x 10-2 6.33 x 10-2 4.00 x 10-3 Based on the temperature and Ksp value obtained in Table 1, values of 1/T and ln Ksp were calculated and tabulated in Table 3. A graph was plotted based on the values: Figure 1: Graph of Ksp versus 1/T From Figure 1, the gradient and y-intercept was obtained as shown in Table 4. The enthalpy change and entropy change was calculated based on the vant hoff equation: Gradient = (/ R) = -5692.06 Standard deviation of gradient: Â ± 99.87 = (-5692.06 x 8.314) Â ± (99.87 x 8.314) = (47.32 Â ± 0.83) kJ K-1 mol-1 Y-intercept = (/ R) = 12.25 Â ± 0.33 Standard deviation of Y-intercept = Â ± 0.33 = (12.25 x 8.314) Â ± (0.33 x 8.314) = (101.85 Â ± 2.74) J K-1 mol-1 The standard error of regression was found to be 0.0295. (Number of measurements = 6, Degree of Freedom = 4) Results and Discussion From the data obtained, the calculated values of and were (47.3 Â ± 0.83) kJ K-1 mol-1 and (101.85 Â ± 2.74) J K-1 mol-1 respectively. Ksp of KHC4H4O6 was found to be 1.32 x 10-3 at 302.15K. It was observed that a linear graph was obtained upon plotting ln Ksp against the reciprocal of T. The increase in temperature was also found to correlate with the increase of Ksp values. The literature Ksp value for KHC4H4O6 is 3.8 x 10-4 at 291.15K. [2] The approximated Ksp value that corresponds to 291.15k based on experimental data was calculated to be 6.755 x 10-4 as shown in the Appendices. Linear Relationship between T and Ksp Based on figure 1, a linear model was observed between the reciprocal of T and the natural logarithm of Ksp. This was supported by the R-square value of 0.99 which greatly suggests a linear trend from the experimental data plotted. The standard error of regression obtained from the experiment was found to be 0.0295, which indicates a good fit among the experimental values obtained, corresponding to a good precision of the experimental data. Thus from the linear trend, the claim of insignificant changes of enthalpy and entropy due to temperature changes was valid. Therefore, the assumption that the value of Ksp is dependent only on temperature at which the dissolution occurs can be established. Comparison of Literature values The estimated Ksp value based on experimental data was 6.755 x 10-4 at 291.15K and was found to be 43.75% higher than the literature value (3.8 x 10-4) [2]. The difference could be accounted to the limitation of this experiment. As the experiment was carried out in different temperature, one of the limitations was due to the apparatus used. The volumetric glass pipette used was calibrated at 20 , thus at other temperature, expansion or contraction might occur leading to the inaccurate volume transferred for titration after the filtering process. Another source of error was noted to be the temperature fluctuation during the filtering process. Although the solution were decant in small portions to minimize errors, rapid increase of the temperature for the cold temperature reading was observed. This corresponds to the increase in the ions concentration dissolved in the solution, thus resulting in a higher value of Ksp. Despite the percentage difference of 43.75%, the difference between both values was actually small due to the fact that the Ksp of KHC4H4O6 is a very small value. When the uncertainty of the enthalpy change and entropy change was taken into account, the experimental Ksp value was assumed to be between 3.446 x 10-4 and 1.324 x 10-3(Refer to Appendices). The literature value was noted to be within this range, thus the experimental data do agree with the theoretical value of KHC4H4O6. Change of Enthalpy and Entropy The change of enthalpy from the reaction was found to be (47.3 Â ± 0.83) kJ K-1 mol-1. The positive enthalpy change means that the dissolution of KHC4H4O6 was an endothermic process where heat was absorbed during the process. This was expected as the dissolution breaks up the stronger ionic bonds within KHC4H4O6 and weaker bonds between the water molecules and the ions was formed. These resulted in a positive net change for enthalpy for the reaction, which is consistent with the positive enthalpy change derived from the experimental data. The change of entropy was found to be (101.85 Â ± 2.74) J K-1 mol-1. As entropy was often defined as a measure of disorder, the positive entropy can be explained with the increased disorder brought about when the when KHC4H4O6 dissolved into ions. As the value of enthalpy change was much larger than the entropy change, in order to get a larger value of ln K based on the vant hoff equation, higher temperature was required. This coincide with high temperature favors endothermic process such as dissolution of KHC4H4O6, thus it can be concluded that temperature have a positive correlation with Ksp. Conclusion Ksp have a linear relationship with temperature for KHC4H4O6. The temperature dependent of enthalpy change and entropy change was found to be insignificant for the dissolution of KHC4H4O6. As dissolution is an endothermic process, temperature has a positive correlation with Ksp, thus higher temperature allow more KHC4H4O6 to dissolve. This concluded that solubility product constant of potassium hydrogen tartrate is dependent only on temperature.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.